Casablanca WHITMAN Owner's Manual page 7

Step 5c. Tighten the set screw with the Allen wrench
as shown in Figure #4 to ensure safe operation of
your fan. If it is tight enough, you should not be able
to turn the downrod counterclockwise with your hands.
If in doubt, tighten the set screw with the Allen wrench
until you cannot turn it any further.
CAUTION: Failure to fully lock in the downrod
before securely tightening the set screw may
cause the fan to separate from the downrod
and fall during normal operation.
Step 5d. Align the three screw holes in the top housing
with the three screw holes on the Pole cover and
screw in the three screws attaching the Pole cover to
the top of the fan as shown in Figure #5.
LIGHTBULB INSTALLATION (uplight) LIGHTBULB INSTALLATION (uplight)
Install Lightbulbs:
Step 6. Insert the fi ve 15-watt lightbulbs for the uplight
as shown in Figure #6.
NOTE: When replacing these lightbulbs, be sure to
use only 15-watt maximum.
WRENCH
Figure #4
POLE COVER
SCREWS (3)
Figure #5
LIGHTBULBS
(5) 15-watt
Uplight Bulbs
Figure #6
W
HITMAN
ALLEN
™
7