Advertisement
Unpacking: Before assembling and installing your ceiling fan, remove all parts from the shipping cartons and check them
against the parts listed here. Before discarding packaging material, be certain that all parts have been removed.
Carton Contents
The fan carton contains the fan body, warranty card, owner's
manual, and all the parts necessary to assemble and install
your Casablanca ceiling fan. These parts are shown at the start
of each installation section. Before you start, go through this
Owner's Manual and confirm that you have all the parts shown
in each section.
ALLEN SET SCREW
⁄
-20 x
⁄
"
1
4
1
4
(pRE-INSTALLED)
imporTanT safeTy informaTion!
BEFORE STARTINg THE INSTALLATION OF YOUR CEILINg FAN, IN-
STALL THE THREADED DOWNROD INTO THE mOTOR COUpLINg AND
prepare for fan installation as follows:
Step A. Route the wires from the motor through the
Perma•Lock™ downrod and ball assembly, keeping the wires
to one side of the cross pin.
noTe: The downrod has a tapered thread
that is designed to lock completely when
correctly installed.
Step B. Using the provided allen wrench, loosen the allen
set screw. Thread the downrod into the motor coupling until
it stops turning, this will take at least four and a half full
turns.
Step C. Securely tighten the allen set screw with the provided
allen wrench to ensure safe operation of your fan.
CAUTION: Failure to fully lock in the down-
rod before securely tightening the allen
set screw may cause the fan to fall during
normal operation!
Installing a New Ceiling Fixture Outlet Box
If you do not have an existing fixture located where you wish
to place your Casablanca fan, an approved ceiling fixture
outlet box must be installed and wired.
Warning: To reduce the risk of fire, electrical shock,
or personal injury, mount to outlet box marked
acceptable for ceiling fan support using the mount-
ing hardware provided with the outlet box.
pREpARATION INSTRUCTIONS
gETTINg STARTED
perma•lock™ hardware
3mm
ALLEN WRENCH
FAN pREpARATION
LOCK THE ASSEmBLY
gETTINg STARTED
Le Grande
Be sure to use only genuine Casablanca blades. The blade
shrink wrap holds 3 blades of matched weight. If more than
one fan is being installed, be sure not to mix blade sets.
CAUTION: When removing the shrink wrap,
be careful not to scratch the blades.
mOTOR
WIRES
TApERED
THREAD
ALLEN
SET SCREW
Using Existing Ceiling Fixture Outlet Box
After turning the power OFF at its source (either circuit
breaker or fuse box), lower the old fixture and disconnect
the wiring. Check the ceiling fixture outlet box to be sure
that it is marked 'Approved for ceiling fan mounting' . If it is
not, a new box must be installed.
noTe: The fan weight is 27 pounds.
™
DOWNROD & BALL
ASSEmBLY
gROUND
WIRE
DOWNROD
& BALL
ASSEmBLY
mOTOR
COUpLINg
3
Advertisement
