Advertisement
Unpacking: Before assembling and installing your ceiling fan,
remove all parts from the shipping cartons and check them
against the parts listed here. Before discarding packaging
material, be certain that all parts have been removed.
ALLEN SET SCREW
¼-20 x ¼"
(pRE-INSTALLED)
imporTanT safeTy informaTion!
BEFORE STARTINg ThE INSTALLATION OF YOUR CEILINg FAN, INSTALL ThE
ThREADED DOWNROD INTO ThE mOTOR COUpLINg AND LOCK ThE ASSEmBLY
prepare for fan installation as follows:
Step A. Route the wires from the motor through the
Perma•Lock™ downrod and ball assembly.
Tip: The downrod has a tapered thread
that is designed to lock completely when
correctly installed.
Step B. Using the provided allen wrench, loosen the set screw
several turns to allow installation of the downrod. Thread the
downrod into the motor coupling until it stops turning, this
will take at least four and a half full turns.
Step C. Securely tighten the set screw with the provided allen
wrench to ensure safe operation of your fan.
CAUTION: Failure to fully lock in the down-
rod before securely tightening the set screw
may cause the fan to separate from the
downrod during normal operation!
CROSSBAR mOUNT-
INg BRACKET
N
O
ew
rleaNs
INSTALLATION INSTRUCTIONS
perma•lock™ hardware
3mm
ALLEN WRENCh
FAN pREpARATION
CEILINg hARDWARE
WIRE NUT (4)
SUppORT INSTALLATION pARTS
LAg SCREW
/
" #7 X 5" (1)
3
8
C
eNteNNial
noTe: Only one set of blade holders is supplied. Depend-
ing on the fan model and series they will be either the
Commodore Style, the Center Style, the Badge Style with
matching badges, or the Standard Style blade holder.
mOTOR
WIRES
TApERED
ThREAD
ALLEN
SET SCREW
addiTional hardware
1" x 8-32 ROUNDED
hEAD SCREW (2)
®
DOWNROD & BALL
ASSEmBLY
gROUND
WIRE
DOWNROD
& BALL
ASSEmBLY
mOTOR
COUpLINg
2
" x 8-32 ROUNDED
1
/
4
hEAD SCREW (2)
FLAT WAShER (2)
LARgE
FLAT WAShER
/
" (1)
3
8
3
Advertisement
