Advertisement
Unpacking: Before assembling and installing your ceiling fan, remove all parts from the shipping cartons and check them
against the parts listed here. Before discarding packaging material, be certain that all parts have been removed.
ALLEN SET SCREW
-20 x
"
1/4
1/4
(pRE-INSTALLED)
imporTanT safeTy informaTion!
BEFORE STARTINg THE INSTALLATION OF YOUR CEILINg FAN, INSTALL THE
THREADED DOWNROD INTO THE mOTOR COUpLINg AND LOCK THE ASSEmBLY
prepare for fan installation as follows:
Step A. Remove the paper shield from top of motor.
Step A1. Route the wires from the motor through the Canopy
Cover Ring and Perma•Lock™ downrod and ball assembly. Slide
the Canopy Cover Ring onto the downrod, pin side up.
Tip: The downrod has a tapered thread
that is designed to lock completely when
correctly installed.
Step B. Using the provided allen wrench, loosen the set screw
several turns to allow installation of the downrod. Thread the
downrod into the motor coupling until it stops turning, this
will take at least four and a half full turns.
Step C. Securely tighten the set screw with the provided allen
wrench to ensure safe operation of your fan.
CAUTION: Failure to fully lock in the downrod before securely
tightening the allen set screw may cause the fan to separate
from the downrod during normal operation!
Installing a New Ceiling Fixture Outlet Box
If you do not have an existing fixture located where you wish
to place your Casablanca fan, an approved ceiling fixture
outlet box must be installed and wired.
warning: To reduce the risk of fire, electrical shock,
or personal injury, mount to outlet box marked ac-
ceptable for ceiling fan support.
INSTALLATION INSTRUCTIONS
perma•lock™ hardware
1/8"
ALLEN WRENCH
FAN pREpARATION
CEILINg HARDWARE
CEILINg
WIRE NUT (4)
pLATE
gETTINg STARTED - CONTINUED
A
urorA
CANOpY
COVER RINg
mOTOR
WIRES
CANOpY
COVER RINg
TApERED
THREAD
ALLEN
SET SCREW
addiTional hardware
SCREW 1"(2)
Using Existing Ceiling Fixture Outlet Box
After turning the power OFF at its source (either circuit
breaker or fuse box), lower the old fixture and disconnect
the wiring. Check the ceiling fixture outlet box to be sure
that it is marked 'Approved for ceiling fan mounting' . If it is
not, a new box must be installed.
NOTE: THE FAN WEIgHT IS 22.9 lbs
II
™
DOWNROD & BALL
ASSEmBLY
gROUND
WIRE
DOWNROD
& BALL
ASSEmBLY
mOTOR
COUpLINg
SCREW 2
" (2)
1
/
4
FLAT WASHER (2)
3
Advertisement
