Preparation; Perma Lock Hardware; Fan Preparation; Ceiling Hardware - Casablanca Brescia Instructions Manual

Unpacking: Before assembling and installing your ceiling fan, remove all parts from the shipping cartons and check them
against the parts listed here. Before discarding packaging material, be certain that all parts have been removed.
AllEn SET SCREw
⁄ -20 x
1
4
(pRE-InSTAllED)

ImPOrTANT SAfETy INfOrmATION!

BEfoRE STARTIng ThE InSTAllATIon of yoUR CEIlIng fAn, InSTAll
ThE ThREADED DownRoD InTo ThE moToR CoUplIng AnD loCK
Prepare for fan installation as follows:
Step A. Route the wires from the motor through the
Perma • Lock™ downrod and ball assembly.
Tip: The downrod has a tapered thread
that is designed to lock completely when
correctly installed.
Step B. Using the provided allen wrench, loosen the set screw
several turns to allow installation of the downrod. Thread the
downrod into the motor coupling until it stops turning, this will
take at least four and a half full turns.
Step C. Securely tighten the set screw with the provided allen
wrench to ensure safe operation of your fan.
CAUTIon: failure to fully lock in the downrod
before securely tightening the allen set screw
may cause the fan to separate from the down-
rod during normal operation!
CRoSSBAR moUnT-
Ing BRACKET
pREpARATIon InSTRUCTIonS
pERmA • loCK™ hARDwARE
⁄ "
1
4
AllEn wREnCh

fAn pREpARATIon

ThE ASSEmBly

CEIlIng hARDwARE

wIRE nUT (4)
SUppoRT InSTAllATIon pARTS
LAG SCREW
/
3
B
1/8"
TApERED
ThREAD
AllEn
SET SCREw
AddITIONAL hArdwArE
1" x 8-32 RoUnDED
hEAD SCREw (2)
" #7 X 5" (1)
8
®
rescia
DownRoD & BAll
ASSEmBly
moToR
wIRES
gRoUnD
wIRE
DownRoD
& BAll
ASSEmBly
moToR
CoUplIng
2 " x 8-32 RoUnDED
1
/
4
hEAD SCREw (2)
flAT wAShER (2)
LARGE
FLAT WASHER
/ " (1)
3
8
3