Selection Of Operation Mode - Toshiba TOSVERT VF-S11 Instruction Manual

5.4

Selection of operation mode

: Command mode selection
: Frequency setting mode selection 1
• Function
These parameters are used to specify which input device (operation panel or terminal board) takes priority
in entering an operation stop command or a frequency setting command (internal potentiometer, VIA, VIB,
operation panel, serial communication device, external contact up/down, VIA+VIB).
<Command mode selection>
Title
Command mode selection
Programmed value
Terminal board
:
operation
Operation panel
:
operation
* There are two types of function: the function that conforms to commands selected by
that conforms only to commands from the terminal board. See the table of input terminal function selection in
Chapter 11.
* When priority is given to commands from a linked computer or terminal board, they have priority over the
setting of
<Frequency setting mode selection>
Title
Frequency setting mode selection 1
Function
0: Terminal board
1: Operation panel
ON and OFF of an external signal Runs and stops operation.
Press the and
.
Function
E-9
Adjustment range
keys on the operation panel to start and stop.
Adjustment range
0: Built-in potentiometer
1: VIA
2: VIB
3: Operation panel
4: Serial communication
5: UP/DOWN from external contact
6: VIA+VIB (Override)
E6581158
Default setting
1
5
, and the function
Default setting
0