Toshiba TOSVERT VF-S11 Instruction Manual page 96

An example of the connection of the open collector OUT terminal
• Output terminal setting
6
6.1.2
• Function
Parameter setting of designated frequency and detection band
Parameter setting of output terminal selection
Note: Select the
+24V
P24
OUT
Ry
NO
CC
Output of the low-speed signal (ON signal) between the RY and RC terminals is the factory default
setting of the output terminal selection parameter. This setting must be changed to invert the polarity of
the signal.
[Parameter setting]
Title
Output terminal selection 1A (RY-RC)
Set to output to OUT-NO terminals.
Output of designated frequency reach signal
: Speed reach detection band
When the output frequency becomes equal to the setting by designated frequency ±
OFF signal is generated.
Title Function
Speed reach detection band
Title Function
Output terminal
selection 2A
(OUT-NO)
parameter to specify RY-RC terminal output, or the
FLA-FLC-FLB terminal output.
An example of the connection of the relay output terminals
Function
0-255
(See Section 11, K-18)
0.0 ∼
Adjustment range
0-255 6: RCH (designated frequency - ON signal), or
(See Section 11, K-18) 7: RCHN (designated frequency - OFF signal)
F-2
+24V
RY
RC
Adjustment range Default setting
4 (ON signal)
5 (OFF signal)
Adjustment range Default setting
(Hz)
Default setting
parameter to specify
E6581158
or
, an ON or
2.5