Toshiba TOSVERT VF-S11 Instruction Manual page 63

4.2.5 Parameters that cannot be changed while running
For safety reasons, the following parameters have been set up so that they cannot be reprogrammed while
the inverter is running. Stop operation ("0.0" or "off" is displayed) before changing parameter settings.
[Basic parameters]
(Automatic acceleration/deceleration)
(Parameter setting macro torque boost)
(Parameter setting macro function)
(Command mode selection)
(Frequency setting mode selection 1)
(Default setting)
(Maximum frequency)
(Base frequency 1)
(Base frequency voltage1)
(V/F control mode selection 1)
[Extended parameters]
∼
∼
∼
∼
∼
∼
∼
The setting of any parameter other than the above can be changed even during operation.
Keep in mind, however, that when the parameter
(prohibited), no parameters can be set or changed.
Set
the inverter is running.
: Priority selection
: Input terminal selection parameters
: Output terminal selection parameters
: Base frequency 2
: Base frequency voltage 2
: Jog stopping pattern
: Protection parameters
: Carrier frequency control mode selection
: Braking mode parameters
: Auto-tuning
: Motor constant parameters
: Motor control parameters
: Emergency stop selection
: Output phase failure detection mode selection
: Input phase failure detection mode selection
: Detection of output short-circuit during start-up selection
: Over-voltage stall protection level
: Under voltage trip/alarm selection
: Logic output/pulse train output selection (OUT-NO)
: PM motor parameters
D-9
, and they can be changed while
(prohibition of change of parameter settings) is set to
E6581158
4