Table of Contents
Advertisement
Operation
Resetting Calibration
Defaults
Setting the
White Color
Calibrating the
White Color
-14-
This setting allows you to reset the product's default values set in the CAL1 and CAL2
programming levels. (See
White Color
for CAL2 settings.)
1. Go to the CAL main level.
2. Enter the passcode (see Passcode).
3. Go to CALR.
4. Enter the passcode (see Passcode).
5. Wait for the reset process to finish.
This setting allows you to select and edit the color temperature of the white used in
Channel 6 when in the TOUR mode or Channel 11 when in TR16 mode.
1. Go to the CAL main level.
2. Enter the passcode (see Passcode).
3. Go to the CAL1 programming level.
4. Select a white color (WH.01–11).
5. Select a color RED (red), GREN (green), BLUE (blue), or WHIT (white).
6. Select a color value 000–255 (0–100%).
7. Repeat for the other colors.
This setting allows you to calibrate the white color when RGBW and the DMX controller's
red, green, and blue faders are set to 255.
1. Go to the CAL main level.
2. Enter the passcode (see Passcode).
3. Go to the CAL2 programming level.
4. Select the desired color RED (red), GREN (green), or BLUE (blue).
5. Select a desired color value 000 to 255 (0–100%).
6. Repeat for the other colors.
When selecting CAL > CAL2 >, you will only be able to define the values of red, green,
and blue.
The values of RED (red), GREN (green), and BLUE (blue) configured from CAL >
CAL2 > will define the color temperature shown when the RGB faders are set to
255 if SET > COLR > RGBW is active.
Setting the White Color
COLORado™ Batten Quad-9 Tour User Manual Rev. 1
for CAL1 settings and
Calibrating the
Advertisement
Table of Contents
