Table of Contents
Advertisement
Operation
Dimmer Profiles
White Calibration
Backlight
Software
Information
Fixture Hours
LED Test
-14-
This setting determines how fast the output of the WELL™ Flex changes when you modify the
values of the red, green, blue, white, and dimmer faders. This setting provides three different
options to simulate the dimming curve of an incandescent lighting product.
1. Go to the Dimmer Mode main level.
2. Select a dimmer profile (Off, Dimmer 1, Dimmer 2, or Dimmer 3).
OFF:
The output is proportional (linear) to the dimmer and RGBW channel values.
Dimmer 1–3: The output follows the dimmer and RGBW channel values based on the
corresponding dimmer curve, Dimmer 1 being the fastest and Dimmer 3 the
slowest.
This setting allows you to select the white color shown by the WELL™ Flex when the DMX
controller's red, green, and blue faders are set to 255.
1. Go to the White Balance main level.
2. Go to Balance.
3. Select a color (R, G, or B).
4. Go to Value.
5. Select a color value (125–255).
6. Repeat for the other colors.
When selecting White Balance, you will only be able to define the values of red (R),
green (G), and blue (B).
The values of red (R), green (G), and blue (B) configured from White Balance will define
the color temperature shown when the RGB faders are set to 255.
This
setting
allows
WELL™ Flex's display stays on after the last button is pressed on the control panel.
1. Go to the BackLite main level.
2. Select On (remains on), 10S (10 seconds), 20S (20 seconds), or 30S (seconds).
This option shows what version of software the WELL™ Flex is running.
1. Go to the Information main level.
2. Select Version and the version number will show on the display.
This option shows the total amount of hours the WELL™ Flex has been turned on.
1. Go to the Information main level.
2. Select Fixture Hours and the total number of hours will show on the display.
This option runs a check of the LEDs on the WELL™ Flex by turning on all the LEDs in
sequence.
1. Go to the Information main level.
2. Select Test programming level.
you
to
set
the
amount
of
time
the
backlight
WELL™ Flex User Manual Rev. 1
on
the
Advertisement
Table of Contents
