Program Upload; Resetting Factory Defaults - Chauvet COLORado Batten Quad-9 Tour User Manual

Program Upload

Resetting Factory
Defaults
COLORado™ Batten Quad-9 Tour User Manual Rev. 1
This option allows you to transfer the custom programs of one product onto another
product using the Master/Slave mode.
1. Configure and connect the products in a Master/Slave arrangement, where the
master has the custom programs you want to transfer to the slaves.
2. From the master, go to the SET main level.
3. Go to the UPLD programming level.
4. Enter the passcode (see Passcode).
5. When SEND shows, press <ENTER> to start the upload.
6. Wait for the upload process to finish (the display will show OK before continuing or
turning the products off.
The Master/Slave products will provide the status of the process by lighting up as
follows:
·
Yellow indicates that the upload process is running.
·
Green indicates that the upload process completed successfully.
·
Red indicates that the upload process failed due to an error. Recheck all cable
connections and restart the process. If the issue persists, contact CHAUVET®
Technical Support.
Do not upload the data from a COLORado™ Batten Quad-9 Tour to a different
product, as the other product may become inoperative.
This setting allows you to reset the product's default values, including the custom
programs.
1. Go to the SET main level.
2. Select REST.
3. Enter the passcode (see Passcode).
4. Wait for the reset process to finish.
Operation
-13-