Effect Macros
The onAir IP Panel 1 features 8 effect macros which simulate lighting effects.
1. Go to the Effect Macros main level.
2. Select the effect macro, from Color Chase, Police Car, Firetruck, Fire, Clouds, Fireworks,
Paparazzi, or Lightning.
3. Set the speed from 001–100.
Settings Configuration
Red Shift
With red shift enabled, the color temperature will warm as the dimmer decreases in imitation of a lamp. To
enable or disable the red shift function:
1. Go to the Red Shift main level.
2. Select from On or Off.
Master/Slave
To set the onAir IP Panel 1 product to master or slave mode:
1. Go to the Master/Slave main level.
2. Select from Master (sends control signal) or Slave (receives control signal).
•
Configure all the slave products before connecting the master to the daisy chain.
•
Never connect a DMX controller to a DMX string configured for Master/Slave operation
because the controller may interfere with the signals from the master.
•
Do not connect more than 31 slaves to the master.
DMX Loss
To set the way in which the product will respond to the loss of a DMX signal:
1. Go to the DMX Loss main level.
2. Select from
•
Hold Last (maintain and send the last DMX values received),
•
Stop DMX (maintain the last DMX values received without sending), or
•
Blackout (set all channels to 000).
Dimmer Curve
To set the dimmer curve:
1. Go to the Red Shift main level.
2. Select from S Curve, Linear, Square, or Inverse Square.
Dimmer Speed Mode
To set the dimmer speed:
1. Go to the Dimmer Mode main level.
2. Select the dimmer speed mode from Off (instant), Dimmer 1 (fastest), Dimmer 2, or Dimmer 3
(slowest).
Color Calibration
To configure the color calibration:
1. Go to the Color Calibration main level.
2. Select from Off, User Calibration, or Factory Calibration.
3. If User Calibration, select the maximum color value to edit, from Red, Green, Blue, or White.
4. Set the maximum level for the selected color, from 125–255.
5. Repeat until the colors are calibrated as desired.
Pulse Width Modulation
To set the frequency of the pulse width modulation:
1. Go to the LED Frequency main level.
2. Select the PWM frequency, from 600Hz, 1200Hz, 2000Hz, 4000Hz, 6000Hz, or 25KHz.
Fan Mode
To set the fan mode:
1. Go to the Fan Mode main level.
2. Select the fan mode, from Auto (adjusts to product temperature), On (always on), Off (always off),
or Silent (silent mode).
22
Operation
onAir IP Panel 1 User Manual Rev. 3