Table of Contents
Advertisement
Reset
Zoom - Menu
Control
Setting Zoom Ranges
Resetting the Zoom
Motor
Zoom - Manual
Control
Performance Power
Output Options
OVATION™ FD-165WW User Manual Rev. 1
To reset the OVATION™ FD-165WW to the factory default settings, follow the instructions
below.
1. Go to the SET main level.
2. Select the REST programming level and then the display becomes blank.
3. Enter the passcode as described in Passcode. After successfully entering the
passcode, REST blinks on the display during the reset process.
4. OK appears on the display when finished.
The OVATION™ FD-165WW offers three zoom options during the operation of the
OVATION™ FD-165WW. To select from these option, do the following.
1. Go to the SET main level.
2. Select the ZOOM programming level.
3. Select from the following options:
· Select BASE for the default zoom position (full movement).
· Select POS1 for the position 1 zoom range.
· Select POS2 for the position 2 zoom range.
These settings allow you to select the zoom ranges for POS1 and POS2 during menu
control of the zoom.
1. Go to the CAL main level.
2. Enter the passcode as described in Passcode.
3. Go to the CALZ programming level.
4. Select POS1 (position 1) or POS2 (position 2).
5. Select the desired maximum for the zoom 000–255 (0–100%).
6. Repeat to select the other position setting.
To reset the zoom's motor, do the following.
1. Go to the MOTR main level.
2. Select YES to reset the zoom's motor.
3. Note: Selecting NO does not reset the zoom's motor.
Manually adjust the zoom by using the zoom adjustment knob, as follows.
1. Press the zoom adjustment knob above the display twice.
2. Select the desired zoom setting Z.000–Z.100 (0–100%).
·
When using the zoom adjustment knob, the lowest zoom value stops at D.000
and the highest zoom value stops at D.100.
·
During manual zoom control, you can also use <UP> or <DOWN>, which will
cycle through all the zoom values.
·
After 30 seconds of zoom adjustment knob inactivity, M. appears on the display.
The OVATION™ FD-165WW offers three power output options during the cooling of the
product's LEDs.
1. Go to the SET main level.
2. Select the PERF programming level.
3. Select from the following options:
· Select LIVE to cool the LEDs by balancing the use of the fan and the power
output level.
· Select STDO to cool the LEDs by maintaining the use of the fan and limiting the
power output level.
· Select POWR to cool the LEDs by maintaining the use of the fan and allowing
full power output.
Operation
-15-
Advertisement
Table of Contents
