Restoring The Operating System - NEC POWERMATE 8100 Series Service And Reference Manual

The other software components required for the operating system are also
loaded from the CD.
After the OS finishes loading, the "Operating System Restore Completed"
screen appears.
9. Remove the CD from the CD tray.
10. Click
OK
This completes the Custom Rebuild and Restore procedure.
To reinstall any of the applications or device drivers that came with the
computer, follow the procedures in "Installing Applications" and in
Appendix A, "Release Notes."
To install device drivers that did not come with the computer, follow the
procedures in "NEC Driver CD."
Restore the applications or drivers that were not provided by NEC by using the
vendor diskettes(s) or CD-ROM(s) included in its original packaging.

Restoring the Operating System

To perform an OS Restore only (the "Fix OS" procedure) for systems running
the Windows 95 or Windows 98 operating system, boot the system from the
Select Install CD. When the system boots from the CD, it automatically loads
the MS-DOS-based Operating System Restore program.
If possible, back up the data files before performing an OS restore.
Follow these steps to restore only the operating system without repartitioning or
reformatting the hard drive.
1. Power on or restart the system and immediately insert the Select Install disc
into the CD-ROM drive.
For systems with a SCSI hard drive, a bootable diskette is included with the
NEC Select Install CD. In SCSI systems, first boot the system from the
bootable diskette. After the system boots, proceed with the NEC Select
Install procedure described below.
After the system boots from the CD, the Operating System Restore
Welcome screen appears (see the following screen).
2-50 System Configuration
to reboot.