5-12
Repair
Figure Section 5-12 Removing the Device Screws
3 1/2-Inch Hard Disk Drive Removal
Remove the 3 1/2-inch hard disk drive as follows.
1.
Remove the system unit cover as previously described.
2.
Unplug the hard disk drive power and signal cables from the hard disk drive.
3.
Remove the four screws, underneath the bottom of the system unit, holding the
3 1/2-inch hard disk drive to the unit (see Figure Section 5-14).
Slide the 3 1/2-inch hard disk drive towards the back of the system unit and
4.
remove the drive from the system.
Figure Section 5-14 Removing the 3 1/2-Inch Hard Disk Drive
NOTE: When reinstalling the drive, note that all
power cables are keyed to fit only in the correct
position.