Updating The Server Configuration - IBM xSeries 200 Hardware Maintenance Manual

Complete the following steps to install the server cover:
1. Clear any cables that might impede the replacement of the cover.
2. Install the side cover:
Note: The cover-release latch must be in the unlocked (opened) position before
reinstalling the cover on the server.
a. Insert the tabs located inside the cover into the slots located on the server
chassis.
b. Close the cover-release latch to secure the cover in place.
Note: Make sure each tab on the cover is in its corresponding slot before
closing the cover-release latch.
3. Lock the cover.
4. If you have not done so already, make sure the stabilizing feet are in the
stabilizing position so that they properly support the server. See "Stabilizing
feet" on page 41 for details.
5. Reconnect the external cables and power cords to the server, and then plug the
power cords into electrical outlets.
6. Turn on all peripheral devices; then, turn on the server.

Updating the server configuration

When you start the server for the first time after you add or remove an internal
option or an external SCSI device, you might see a message telling you that the
configuration has changed. The Configuration/Setup Utility program automatically
starts so that you can save the new configuration information. See "Configuration"
on page 25.
63
Installing options