Ndis 4.0 Windows Driver Messages - IBM xSeries 200 Hardware Maintenance Manual

Table 4. NetWare driver messages for the Ethernet controller (continued)
Message
LAN adapter at slot nnnn
(Port 0xaa) failed to reset.
Check the state of the
adapter.
AFT is not supported on this
version of NetWare
Failed to allocate resources
tags.
Please unload all LAN
drivers before unloading
AFT.NLM.

NDIS 4.0 Windows driver messages

This section contains the error messages for the NDIS 4.0 drivers. The explanation
and recommended action are included with each message.
Table 5. NDIS (Windows NT or Windows 2000) driver messages for the Ethernet controller
Error code
(hex)
0x00
0x01
0x02
0x03
0x0D
Description
Explanation: The adapter that you specified could not be
initialized.
Action:
1. Load the driver for the supported adapter.
2. Check that the adapter is seated properly in the slot and
try loading the AFT module again.
If the problem persists, contact your network supplier.
Explanation: The NetWare on the server is not a version
™
. supported by AFT.
Action: Load and bind AFT only on supported versions of
NetWare (currently version 4.11 and above).
Explanation: An unknown error has occurred when trying
to allocate needed resources for the AFT module.
Action: Check server configuration. If the problem persists,
contact your network supplier.
Explanation: An attempt was made to unload the AFT.NLM
module before unloading the adapter driver.
Action: Unload the adapter driver before unloading the
AFT module.
Description
Explanation: The driver could not register the specified interrupt.
Action: Using the Configuration/Setup Utility program, make sure that a
PCI interrupt is assigned to your Ethernet card, and that Ethernet is
enabled.
Explanation: One of the PCI cards did not get the required resources.
Action: Using the Configuration/Setup Utility program, make sure that a
PCI interrupt is assigned to your Ethernet card, and that Ethernet is
enabled.
Explanation: Bad node address (multicast address).
Action: Make sure the locally administered address is valid, if one is
specified. The address can not be a multicast address.
Explanation: Failed self-test.
Action: Make sure a cable is attached to the Ethernet connector.
Explanation: Could not allocate enough memory for transmit queues.
Action:
1. From the Windows NT desktop, select Start " Control Panel "
Networks " Adapters.
2. Select your IBM Ethernet adapter from the list.
3. Select Properties " Advanced.
4. Lower the resource values that apply to the transmit queue.
21
Diagnostics