IBM xSeries 200 Hardware Maintenance Manual page 60

52
xSeries 200 Type 8479 and xSeries 200VL Type 8481: Hardware Maintenance Manual
2. Turn off the server and peripheral devices and disconnect external cables and
power cords; then, remove the side cover (see "Side cover removal" on page
42 for details).
3. Remove the support bracket assembly and disconnect the fan cable from the
connector (SYSFA1) on the system board. See "Removing the support bracket
assembly" on page 45 and "System board internal cable connectors" on page
38 for the location of the fan cable connector.
4. Use a screwdriver to gently pry the filler panel and EMC shield away from
the server.
Note: If you are installing a drive that is a laser product, observe the
following safety precaution:
Statement 3:
CAUTION:
When laser products (such as CD-ROMs, DVD drives, fiber optic devices,
or transmitters) are installed, note the following:
v Do not remove the covers. Removing the covers of the laser product could
result in exposure to hazardous laser radiation. There are no serviceable
parts inside the device.
v Use of controls or adjustments or performance of procedures other than
those specified herein might result in hazardous radiation exposure.
DANGER: Some laser products contain an embedded Class 3A or Class 3B
laser diode. Note the following: Laser radiation when open. Do
not stare into the beam, do not view directly with optical
instruments, and avoid direct exposure to the beam.
5. Touch the static-protective package containing the drive to any unpainted
metal surface on the server; then, remove the drive from the package and
place it on a static-protective surface.
6. Set any jumpers or switches on the drive according to the documentation that
comes with the drive.
7. Install the drive.
v If you are installing a 5.25-in drive in bay 2, push the drive into the bay;
then, use the two screws to attach the drive to the drive cage.
v If you are installing a 3.5-in drive in bay 2, you must attach the 5.25-in
conversion kit, supplied with your option, to the 3.5-in drive.
8. Cable the drive.
v If the drive is an IDE device, plug one connector of the IDE signal cable
into the back of the drive and the other end of the cable into the IDE
connector (IDE1) on the system board. For the location of the IDE
connectors, see "System board internal cable connectors" on page 38.