2. Connect the SCSI signal cable to the adapter and one or more of the signal
3. Connect the SCSI activity indicator cable to the adapter and to the SCSI LED
4. If you have another adapter to install or remove, do so now.
5. If you have installed a full-length adapter, rotate the front adapter support
6. Reinstall the rear adapter retaining bracket; then, rotate the bracket to the
7. If you have other options to install, do so now.
8. Reinstall the side cover (see "Installing the cover" on page 62).
9. Reconnect the external cables and power cords; then, turn on the peripheral
Internal drive installation
Depending on the server model, you might have one or more of the following
drives installed.
v Diskette
v Hard disk
v CD-ROM
SCSI
signal
cable
Adapter
retaining
bracket
SCSI signal
cable connector
SCSI activity
indicator cable
SCSI
connector
Adapter
cable connectors to the rear of the SCSI devices.
connector (J3) on the system board. See "System board internal cable
connectors" on page 38 for the location of this connector.
Note: If you are installing or replacing an adapter that will control your startup
(boot) drive, install the adapter in PCI expansion slot 2.
bracket to the closed (locked) position.
closed (locked) position.
devices and the server.
SCSI
activity
SCSI
Adapter
indicator
LED
support
cable
(J3)
bracket
49
Installing options