Adapter Installation - IBM xSeries 200 Hardware Maintenance Manual

changed the default boot sequence: PCI expansion slots 1 through 5; then the
system board integrated drive electronics (IDE) or SCSI devices.
Note: To change the startup sequence for PCI devices, start the
Configuration/Setup Utility program, select Start Options from the main
menu, select Startup Sequence; then, select Second device (SCSI) to
designate the adapter boot sequence. See "Configuration" on page 25 for
details on using the Configuration/Setup Utility program.
v For a list of supported options for the server, refer to http://www.ibm.com/pc/
compat on the World Wide Web.

Adapter installation

Expansion
slot cover
Adapter
retaining
bracket
Complete the following steps to install an adapter:
Attention:
damage from static electricity. For details on handling these devices, see "Handling
electrostatic discharge-sensitive devices" on page 106.
1. Review the information in "Before you begin" on page 40.
2. Turn off the server and peripheral devices and disconnect all external cables
and power cords; then, remove the side cover. See "Side cover removal" on
page 42 for details.
3. Determine which PCI expansion slot you will use for the adapter.
Note: If you are installing or replacing an adapter that will control your
startup (boot) drive, install the adapter in PCI expansion slot 2.
4. If you are installing a full-length adapter, rotate the front adapter support
bracket to the open (unlocked) position.
Adapter
When you handle static-sensitive devices, take precautions to avoid
Adapter
support
bracket
47
Installing options