Ethernet Teaming Messages - IBM xSeries 200 Hardware Maintenance Manual

Ethernet teaming messages:

This section displays the messages associated with Ethernet teaming.
22
xSeries 200 Type 8479 and xSeries 200VL Type 8481: Hardware Maintenance Manual
Table 5. NDIS (Windows NT or Windows 2000) driver messages for the Ethernet
controller (continued)
Error code
(hex) Description
0x0E Explanation: Could not allocate enough memory for receive queue.
Action:
1. From the Windows NT desktop, select Start "Control Panel "Networks
"Adapters.
2. Select your IBM Ethernet adapter from the list.
3. Select Properties "Advanced.
4. Lower the resource values that apply to the receive queue.
0x0F Explanation: Could not allocate enough memory for other structures.
Action:
1. From the Windows NT desktop, select Start " Control Panel "
Networks " Adapters.
2. Select your IBM Ethernet adapter from the list.
3. Select Properties "Advanced.
4. Lower the value for the resource named in the message.
0x10 Explanation: Did not find any Ethernet controllers.
Action: Using the Configuration/Setup Utility program, make sure that
Ethernet is enabled.
0x11 Explanation: Multiple Ethernet controllers found, but none matched the
required ID.
Action: Using the Configuration/Setup Utility program, make sure that
Ethernet is enabled.
0x13 Explanation: Did not find any Ethernet controllers that matched the
required subven/subdev.
Action: Using the Configuration/Setup Utility program, make sure that
Ethernet is enabled.
0x16 Explanation: Single adapter found, but multiple instances tried to load.
Action: Using the Configuration/Setup Utility program, make sure that
Ethernet is enabled, and that the slot containing the IBM xSeries 200
10/100 Ethernet Adapter or the IBM 10/100 Etherjet PCI adapter is
enabled.
0x17 Explanation: Slot parameter not specified in the registry.
Action: Remove the adapter driver and reinstall it.
Table 6. NDIS (Windows NT or Windows 2000) driver teaming messages for the Ethernet
controller
Event ID Type
01 Error
02 Error
Description
Explanation: Team name and physical adapter name are
the same. This is an invalid configuration.
Action: Reconfigure the adapter team by double-clicking
the PROSet icon in the control panel.
Explanation: Unable to allocate required resources.
Action: Free some memory resources and restart.