Removing The Support Bracket Assembly - IBM xSeries 200 Hardware Maintenance Manual

Removing the support bracket assembly

When working with some options such as hard disk drives, microprocessors, and
memory modules you must first remove the support bracket assembly to access
the location of the option.
Complete the following steps to remove the support bracket assembly:
1. Review the information in "Before you begin" on page 40.
2. Turn off the server and peripheral devices and disconnect all external cables
3. Disconnect the support bracket assembly fan cable from the connector (SYSFA1)
4. Locate the end of the support-bracket assembly near the rear of the server. Pull
5. Pull the front end of the support bracket assembly away from the server and
To reinstall the support bracket assembly, reverse the previous steps.
and power cords; then remove the side cover (see "Side cover removal" on
page 42).
on the system board. For the location of the fan connector, see "System board
internal cable connectors" on page 38.
it out approximately 152.4 mm (6 in.).
place the assembly aside.
45
Installing options