Choices Available From The Scsiselect Menu - IBM xSeries 200 Hardware Maintenance Manual

v Press the F5 key to switch between color and monochrome modes (if your
monitor permits).
5. Follow the instructions on the screen to change the settings of the selected
items; then, press Enter.

Choices available from the SCSISelect menu

The following choices appear on the SCSISelect Utility menu:
v Configure/View Host Adapter Settings
Select this choice to view or change the SCSI controller settings. To reset the
SCSI controller to its default values, press the F6 key; then, follow the on-screen
instructions.
You can view or change the following controller settings:
– Host Adapter SCSI ID
Select this choice to view the SCSI controller identification (ID), which is
usually 7.
– SCSI Parity Checking
Select this choice to view the assigned value. The assigned value is Enabled,
and cannot be changed.
– Host Adapter SCSI Termination
Select this choice to view the assigned value. The assigned value is Automatic,
and cannot be changed.
– Boot Device Options
Select this choice to configure startable-device parameters. Before you can
make updates, you must know the ID of the device whose parameters you
want to configure.
– SCSI Device Configuration
Select this choice to configure SCSI-device parameters. Before you can make
updates, you must know the ID of the device whose parameters you want to
configure.
Note: The Maximum Sync Transfer Rate is the transfer rate for Ultra SCSI
devices.
- The transfer rate for Ultra 160 low voltage differential (LVD) devices
- The transfer rate for Ultra2 SCSI LVD devices is 80.0 MBps.
- The transfer rate for Fast SCSI devices is 20.0 MBps.
– Advanced Configuration Options
Select this choice to view or change the settings for advanced configuration
options. These options include support for large hard disk drives and support
for drives with UltraSCSI speeds.
is 160.0 MBps.
29
Configuration