IBM xSeries 200 Hardware Maintenance Manual page 35

You can select keyboard operating characteristics, such as the keyboard speed.
You also can specify whether the server starts with the keyboard number lock on
or off.
The server uses a startup sequence to determine the device from which the
operating system starts. For example, you can define a startup sequence that
checks for a startable diskette in the diskette drive, then checks the hard disk
drive in a drive bay, and then checks a network adapter.
You can enable a virus-warning test that checks for changes in the master boot
record at startup. You also can choose to run POST in the quick mode, and read
the microprocessor serial number.
v Frequency Control
Select this choice to enable or disable the auto-detect DIMM/PCI clock.
v Date and Time
Select this choice to set the system date and time.
The system time is in a 24-hour format: hour:minute:second.
Note: You may also set the date and time using the procedures provided on the
ServerGuide CDs.
v System Security
Select this choice to set a power-on or an administrator password. See "Using
passwords" on page 28 for more information.
v Advanced Setup
Select this choice to change values for advanced hardware features, such as
Cache Control and PCI configuration.
A message appears above the choices on this menu to alert you that the system
might malfunction if these options are configured incorrectly. Follow the
instructions on the screen carefully.
– Cache Control
Select this choice to enable or disable the microprocessor cache.
The Cache Control should only be modified by an IBM
Attention:
authorized service representative.
– ROM Shadowing
Select this choice to enable or disable the state of a ROM shadowing.
– Chipset Feature
Select this choice to modify settings that control features of the core chip set
on the system board.
Attention: The Chipset Feature should only be modified by an IBM
authorized service representative.
– Memory Settings
If a memory error is detected during POST or memory configuration, the
server can automatically disable the failing memory bank and continue
operating with reduced memory capacity. If this occurs, you must manually
enable the memory bank after the problem is corrected. Select Memory
Settings from the Advanced Setup menu, use the arrow keys to highlight the
bank that you want to enable; then, use the arrow keys to select Enable.
v Power Management Setup
Select this choice to enable or disable system power savings.
v Save and Exit Setup
Select this choice to save the customized settings.
27
Configuration