IBM xSeries 200 Hardware Maintenance Manual page 104

Error Symptom
Floppy disk(s) fail (cannot
find or initialize floppy drive
controller or floppy drive)
HARD DISK initializing
HARD DISK INSTALL
FAILURE (cannot find or
initialize hard drive controller
or hard drive)
Hark disk(s) diagnosis fail (a
diagnostic routine has failed)
Keyboard error or no
keyboard present (cannot
initialize keyboard)
Keyboard is locked out --
Unlock the key (key(s)
pressed during keyboard
tests)
Memory Test: (countdown as
memory areas are tested)
Memory test fail (POST
detected an error during
memory testing)
Override enabled -- Defaults
loaded (system cannot boot
using current CMOS
configuration; BIOS has
overridden configuration and
defaulted to
minimal-performance system
operations)
Primary master hard disk
fail (error detected in
primary master IDE hard
drive)
Primary slave hard disk fail
(error detected in primary
slave IDE hard drive)
Secondary master hard disk
fail (error detected in
secondary master IDE hard
drive)
Secondary slave hard disk
fail (error detected in
secondary slave IDE hard
drive)
96
xSeries 200 Type 8479 and xSeries 200VL Type 8481: Hardware Maintenance Manual
FRU/Action
1. Reseat controller
2. If no floppy drive installed, be sure Diskette Drive selection in Setup is set to
None or Auto.
1. Informational only; no action necessary.
2.
1. Reseat drive
2. If no hard drive installed, be sure Hard Drive selection in Setup is set to None.
1. Run Configuration/Setup
2. Battery
3. System board
1. Reattach keyboard
2. Ensure no keys are pressed during POST
3. To configure system to run without a keyboard, set error halt condition in Setup
to HALT ON ALL, BUT KEYBOARD. BIOS will then ignore missing keyboard
during POST.
1. Ensure no keys are pressed during POST
2. Clear keyboard of any object resting on it
1. Informational only; no action necessary.
2.
1. Note additional information about specific error that appears on the screen
2. DIMM
1. Run Configuration/Setup
2. Battery
3. System board
1. Replace primary master hard drive
2. System board
1. Replace primary slave hard drive
2. System board
1. Replace secondary master hard drive
2. System board
1. Replace secondary slave hard drive
2. System board