Table of Contents
Advertisement
Removing the support-bracket assembly
When working with some options such as hard disk drives, microprocessors, and
memory modules, you must first remove the support-bracket assembly to access the
location of the option.
Complete the following steps to remove the support-bracket assembly.
1. Review the safety precautions listed in "Safety" on page v.
2. Turn off the server and peripheral devices and disconnect all external cables and
3. Disconnect the support-bracket assembly fan cable from the connector (SYSFA3)
4. Locate the end of the support-bracket assembly near the rear of the server. Pull it
5. Pull the front end of the support-bracket assembly away from the server and place
To reinstall the support-bracket assembly, reverse these steps.
10
IBM xSeries 200 and xSeries 200VL: Installation Guide
power cords; then, remove the side cover. See "Removing the side cover" on
page 9 for details.
on the system board. For the location of the fan cable connector, see "System
board internal cable connectors" on page 5.
out approximately 152.4 mm (6 in.).
the assembly aside.
Advertisement
Table of Contents
