[Network] Menu; [Wired Lan] - Panasonic PT-VW340Z Operating Instructions Manual

[NETWORK] menu

On the menu screen, select [NETWORK] from the main menu, and select an item from the submenu.
Refer to "Navigating through the menu" (
After selecting the item, press
f

[WIRED LAN]

You can make detailed wired LAN settings.
1) Press as to select [WIRED LAN].
2) Press the <ENTER> button.
The [WIRED DETAILED SETUP] screen is displayed.
f
3) Press as to select an item, and change the setting according to the instructions.
[DHCP]
[IP ADDRESS]
[SUBNET MASK]
[DEFAULT GATEWAY]
[DNS1]
[DNS2]
4) Press as to select [OK], and press
Default wired LAN settings
r
The following settings are set before the projector leaves the factory.
f
Note
When using a DHCP server, confirm that the DHCP server is running.
f
Consult your network administrator regarding the IP ADDRESS, SUBNET MASK, and DEFAULT GATEWAY.
f
76 - ENGLISH
Chapter 4 Settings - [NETWORK] menu
Æ
page 45) for the operation of the menu screen.
asqw to set.
[ON]: If a DHCP server exists in the network to which the projector is connected,
the IP address will automatically be acquired.
[OFF]: If a DHCP server does not exist in the network to which the projector is
connected, additionally set [IP ADDRESS], [SUBNET MASK] and
[DEFAULT GATEWAY].
Enter the IP address if DHCP server is not used.
If not using a DHCP server, enter the subnet mask.
Enter the gateway address if DHCP server is not used.
Enter the DNS server address if DHCP server is not used.
Enter the alternate DNS server address if DHCP server is not used.
the <ENTER> button.
[DHCP]
[IP ADDRESS]
[SUBNET MASK]
[DEFAULT GATEWAY]
[DNS1] / [DNS2]
OFF
192.168.10.100
255.255.255.0
192.168.10.1
NONE