Contents Of Mail Sent - Panasonic PT-VW340Z Operating Instructions Manual

Contents of mail sent

Example of E-mail sent when E-mail is set
Mail with the contents shown below is sent when the e-mail settings have been established.
=== Panasonic projector report(CONFIGURE) ===
Projector Type
Serial No
-----
TEMPERATURE WARNING SETUP
MINIMUM TIME
INTAKE AIR TEMPERATURE
ERROR
LAMP RUNTIME
LAMP RUNTIME
INTAKE AIR TEMPERATURE
-----
FAN
FAN (INTAKE)
FAN (EXHAUST)
FAN (LAMP)
INTAKE AIR TEMPERATURE
EXHAUST AIR
OPTICS MODULE TEMPERATURE
LAMP REMAIN TIME
LAMP STATUS
APERTURE (CONTRAST-SHUTTER)
AIR FILTER
(Error code 00 00 00 00 00 00 00 00)
Intake air temperature
Exhaust air temperature
Optics module temperature
PROJECTOR RUNTIME
LAMP NORMAL
LAMP ECO1
LAMP ECO2
LAMP REMAIN
-------- Current status ---------
MAIN VERSION
NETWORK VERSION
SUB VERSION
LAMP STATUS
INPUT
SIGNAL NAME
SIGNAL FREQUENCY
----- Wired Network configuration -----
DHCP Client
IP address
MAC address
----- Memo -----
Chapter 4 Settings - [NETWORK] menu
: PT-VW340Z
: 000000000
E-mail setup data -----
at [ 60] minutes interval
Over [ 32degC / 89degF ]
[ OFF ]
[ OFF ]
[ OFF ]
[ OFF ]
check system -----
TEMPERATURE
: 31 degC /
: 37 degC /
: 39 degC / 102 degF
800 H
100 H
500 H
200 H
3400 H
1.00
1.00
1.00
LAMP=ON
RGB
XGA6
0.00kHz / 0.00Hz
OFF
192.168.10.100
04:20:9A:00:00:00
at REMAIN [ 400] H
at REMAIN [ 200] H
[ OK ]
[ OK ]
[ OK ]
[ OK ]
[ OK ]
[ OK ]
[ OK ]
[ OK ]
[ OK ]
[ OK ]
[ OK ]
87 degF
98 degF
ENGLISH - 87