Powering On The Projector; Making Adjustments And Selections - Panasonic PT-VW340Z Operating Instructions Manual

Powering On the Projector

Before switching on the projector, make sure all the other devices are correctly connected (
lens cap.
1)
1) Connect the power cord to the projector body.
2) Connect the power plug to an outlet.
The power indicator <ON(G)/STANDBY(R)> lights or blinks, and the projector will enter the standby mode.
f
3) Press the < v/b> button on the control panel or on the remote control.
The power indicator <ON(G)/STANDBY(R)> lights in green and the image is soon projected on the screen.
f
Attention
Using the projector while the lens cap is attached may cause the device to heat up and result in a fire.
f
Note
If the [PROJECTOR SETUP] menu
f
seconds longer before the projector starts projecting after the power is turned on, compared with when [NORMAL] is set.

Making adjustments and selections

It is recommended that images are projected continuously for at least 30 minutes before the focus is adjusted.
1) Adjust the focus of the image roughly. (
2) Change the settings of the [PROJECTOR SETUP] menu → [PROJECTION METHOD] depending on
the installation mode. (
Refer to "Navigating through the menu" (
f
3) Press the <INPUT SELECT> button on the control panel or the input selection (<COMPUTER 1>,
<COMPUTER 2>, <HDMI>, <VIDEO>,<S-VIDEO>) buttons to select the input signal.
4) Adjust the front, back and sideway tilt of the projector with the adjustable feet. (
5) If the input signal is an analog RGB signal, press the <AUTO SETUP> button.
6) Adjust the size of the image to match the screen with the zoom ring.
7) Adjust the focus with the focus ring.
Note
When the projector is switched on for the first time after purchase as well as when the [PROJECTOR SETUP] menu →
f
[INITIALIZE ALL] is executed, the initial setting screen is displayed after projection starts. Refer to "Start-up display" for
Æ
details. ( page 19)
36 - ENGLISH
Chapter 3 Basic Operations - Powering on/off
2)
→ [ECO MANAGEMENT]→[STANDBY MODE] is set to
Æ
page 38)
Æ
page 25)
Æ
page 45) for the operation of the menu screen.
Æ
3)
3)
3)
5)
pages 31-32 ) and remove the
3)
[ECO], it may take approx. 10
Æ
page 28)