[Shift]; [Dot Clock]; [Clock Phase] - Panasonic PT-VW340Z Operating Instructions Manual

[SHIFT]

(Only for computer signal input)
Move the image position vertically or horizontally if the image position projected on the screen is shifted even when the relative
position of the projector and the screen is installed correctly.
1) Press as to select [SHIFT].
2) Press the <ENTER> button.
The [SHIFT] screen is displayed.
f
3) Press asqw to adjust the position.
Orientation
Vertical (up and down)
adjustment.
Horizontal (right and left)
adjustment.

[DOT CLOCK]

(Only for still image computer (RGB) signals input)
Use this function to adjust and minimize the effect of interference caused by projection of patterns consisting of vertical stripes.
The projection of the following striped pattern may cause cyclic patterns (noise). Adjust so that the amount of interference is at
a minimum. You can adjust the dot lock of image.
1) Press as to select [DOT CLOCK].
2) Press qw or the <ENTER> button.
The [DOT CLOCK] individual adjustment screen is displayed.
f
3) Press qw to adjust the value.
The adjustment value are -32 to +32.
f
Attention
Set it before adjusting [CLOCK PHASE].
f

[CLOCK PHASE]

(Only for computer (RGB) signals input)
You can adjust to achieve an optimal image when there is a flickering image or smeared outlines.
1) Press as to select [
2) Press qw or the <ENTER> button.
The [CLOCK PHASE] individual adjustment screen is displayed.
f
3) Press qw to adjust the value.
The adjustment values are -16 to +16. Adjust so that the amount of interference is at a minimum.
f
56 - ENGLISH
Chapter 4 Settings - [POSITION] menu
Operation
Press the a button.
Press the s button.
Press the
w button.
Press the
button.
q
].
CLOCK PHASE
Adjustment
The image position moves up.
The image position moves down.
The image position moves to the
right.
The image position moves to the
left.