Projecting; Selecting The Input Signal; How To Adjust The State Of The Image - Panasonic PT-VW340Z Operating Instructions Manual

Projecting

Check the connections of the peripheral devices and connection of the power cord (
Æ
( page 36) to start the projector. Select the image and adjust the state of the image.

Selecting the input signal

Select an input signal.
1) Press <COMPUTER 1>, <COMPUTER 2>, <HDMI>, <VIDEO>, or <S-VIDEO> button on the remote control or
<INPUT SELECT> button on the control panel.
The image of the signal being input in the selected terminal is projected.
f
You can check the input source through [DETAILED] / [SIMPLE] under the [DISPLAY OPTION] → [ON-SCREEN
f
DISPLAY] → [INPUT GUIDE] menu.
You can also select the input source by pressing
f
Attention
Images may not be projected properly depending on the connected device and DVD, video tape, etc. to be played. Set the
f
[PICTURE] menu → [RGB/YC
Check the aspect ratio of the screen and the image and select the optimum aspect ratio under the [POSITION] menu
f
(xpage 57).

How to adjust the state of the image

If the projected image or the position is not correct when the positioning of the projector and the screen is correctly installed, adjust the focus
and zoom.
1) Adjust the projection angle.
Install the projector on a flat surface and parallel to the screen so that the projected screen is rectangular.
f
If the screen is tilted downward, extend the adjustable feet and adjust the projection screen so that the projected screen
f
is rectangular.
For details, see "Adjusting adjustable feet" (
f
2) Adjust the zoom and the focus.
Rotate the zoom ring to zoom in and out the image.
f
Rotate the focus ring to adjust the focus of the projected image.
f
Note
It is recommended that the images are projected continuously for at least 30 minutes before the focus is adjusted.
f
If you adjust the focus, you may need to adjust the size of the image by turning the zoom ring again.
f
If keystone distortion occurs, see the [POSITION] menu → [KEYSTONE] (
f
38 - ENGLISH
Chapter 3 Basic Operations - Projecting
asqw on the [DETAILED] screen.
[DETAILED] input guide
Æ
C ] or [RGB/YP P ] ( page 53).
B R B R
Æ
page 28).
Æ
pages 29-34) and switch on the power
[SIMPLE] input guide
If there is no signal input
([COMPUTER 1], [COMPUTER 2] or
[HDMI]), this screen will be displayed.
Check the output settings of your
computer.
Zoom ring
Focus ring
Æ
page 54).