Precautions for use
Cautions when transporting
When transporting the projector, hold it securely by its bottom and avoid excessive vibration and impacts. Doing
f
so may damage the internal parts and result in malfunctions.
Do not transport the projector with the adjustable feet extended. Doing so may damage the adjustable feet.
f
Cautions when installing
Do not set up the projector outdoors.
r
The projector is designed for indoor use only.
f
Do not use under the following conditions.
r
Places where vibration and impacts occur such as in a car or vehicle: Doing so may damage the internal parts
f
and result in malfunctions.
Near the exhaust of an air conditioner or near lights (studio lamps, etc.) where temperature changes greatly
f
(Operating environment
outer case and malfunctions.
Near high-voltage power lines or near motors: Doing so may interfere with the operation of the projector.
f
Be sure to ask a specialized technician when installing the product to a ceiling.
r
This requires an optional ceiling mount bracket.
Model No.: ET-PKV100H (for high ceilings), ET-PKV100S (for low ceilings),
ET-PKV101B
When using the projector in the elevation of below 1 400 m (4 593
r
ALTITUDE MODE] is set to [OFF].
Failure to do so may shorten the life of the internal parts and result in malfunctions.
When using the projector in the elevation of above 1 400 m (4 593
r
2 000 m (6 562'), make sure [HIGH ALTITUDE MODE] is set to [HIGH1].
Failure to do so may shorten the life of the internal parts and result in malfunctions.
When using the projector in the elevation of above 2 000 m (6 562
r
2 700 m (8 858') , make sure [HIGH ALTITUDE MODE] is set to [HIGH2].
Failure to do so may shorten the life of the internal parts and result in malfunctions.
Do not install the projector at elevations of 2 700 m (8 858
r
Failure to do so may shorten the life of the internal parts and result in malfunctions.
Do not tilt the projector or place it on its side.
r
Do not tilt the projector body more than approximately
tilting may result in shortening the life of the components.
Within 40°
Within 40°
14 - ENGLISH
Chapter 1 Preparation - Precautions for use
Æ
page 111): Doing so may shorten the life of the lamp or result in deformation of the
(Projector Mount Bracket).
') or higher above sea level.
±40
degrees vertically or ±15 degrees horizontally. Over
Within 15°
Within 15°
'), make sure [HIGH
') and below
') and below