Projector Body - Panasonic PT-VW340Z Operating Instructions Manual

Note
The remote control can be used within a distance of about 7 m (22.97') if pointed directly at the remote control signal
f
receiver. The remote control can control at angles of up to ± 30 ° vertically and ± 30 ° horizontally, but the effective control
range may be reduced.
If there are any obstacles between the remote control and the remote control signal receiver, the remote control may not
f
operate correctly.
You can operate the projector by reflecting the remote control signal on the screen. The operating range may differ due to
f
the loss of light caused by the properties of the screen.
When the remote control signal receiver is lit with a fluorescent light or other strong light source, the projector may become
f
inoperative. Set the projector as far from the luminous source as possible.

Projector body

1
5
4
WARNING
Keep your hands and other objects away from the air exhaust port.
Keep your hand and face away.
f
Do not insert your finger.
f
Keep heat-sensitive articles away.
f
Heated air from the air exhaust port can cause burns or external damage.
1 Zoom ring (Back)
Adjust the zoom.
2 Control Panel and Indicators (
Æ
3 Lamp cover (
The lamp unit is located inside.
4 Projection Lens
5 Focus ring (Front)
Adjust the focus.
6 Remote control signal receiver
7 Air exhaust port
Attention
Do not block the ventilation ports (intake and exhaust) of the projector.
f
Chapter 1 Preparation - About your projector
2
3
6 7
Æ
page 22)
page 97)
8
13
12
8 Speaker
9 <AC IN> terminal
Connect the supplied power cord.
10 Rear terminals (
11 Air intake port / Air filter cover (
The air filter unit is inside.
12 Adjustable feet
Adjust the projection angle.
13 Security Chain Hook
Attaches a burglar prevention cable, etc.
9
10
Æ
page 22)
ENGLISH - 21
11
Æ
page 95)