Dual Channel Measurement - Tenma 72-6802 User Manual

6. If necessary, use the TIME/DIV
knob to adjust the horizontal
scale manually. Use the
horizontal POSITION knob to
adjust the position of the
waveform.
MEASUREMENT

Dual Channel Measurement

Steps
29 30
1. Connect both CH1 and CH2
signals to the input terminals.
2. Select the vertical coupling
between AC (DC components
are blocked) or DC (all signal
components appear) for both
channels.
3. Configure the trigger settings.
For details, see page19.
Make sure the trigger SOURCE
switch is in either the CH1 or
CH2 position.
4. Set the vertical MODE switch to
the DUAL position.
5. Both the CH1 and CH2 signals appear on the
display.
72-6802 User Manual