Product Overview; Power Cord For The United Kingdom; Product Description - Tenma 72-6802 User Manual

Power cord for the United Kingdom

When using the instrument in the United Kingdom, make sure the
power cord meets the following safety instructions.
NOTE: This lead/appliance must only be wired by competent persons
WARNING: THIS APPLIANCE MUST BE EARTHED
IMPORTANT: The wires in this lead are coloured in accordance with the
following code:
Green/ Yellow: Earth
Blue: Neutral
Brown: Live (Phase)
As the colours of the wires in mains leads may not correspond with the
colours marking identified in your plug/appliance, proceed as follows:
The wire which is coloured Green & Yellow must be connected to the Earth
terminal marked with the letter E or by the earth symbol
or Green & Yellow.
The wire which is coloured Blue must be connected to the terminal which is
marked with the letter N or coloured Blue or Black.
The wire which is coloured Brown must be connected to the terminal marked
with the letter L or P or coloured Brown or Red.
If in doubt, consult the instructions provided with the equipment or contact
the supplier.
This cable/appliance should be protected by a suitably rated and approved
HBC mains fuse: refer to the rating information on the equipment and/or user
instructions for details. As a guide, cable of 0.75mm
a 3A or 5A fuse. Larger conductors would normally require 13A types,
depending on the connection method used.
Any moulded mains connector that requires removal /replacement must be
destroyed by removal of any fuse & fuse carrier and disposed of immediately,
as a plug with bared wires is hazardous if a engaged in live socket. Any re-
wiring must be carried out in accordance with the information detailed on this
label.
SAFETY INSTRUCTIONS
or coloured Green
should be protected by
2
9
P
RODUCT OVERVIEW

Product Description

The Tenma Model 72‐6802 oscilloscope is a portable, dual‐channel
oscilloscope. It provides maximum 30MHz DC bandwidth and
1mV/DIV sensitivity. Its time base reaches 0.2μS/DIV and the sweep
speed 100nS/DIV. The 72‐6802 uses a 6‐inch rectangular cathode ray
tube display with red internal graticule. This is a sturdy, easy‐to‐
operate, and highly reliabile product. The 72‐6802 also incorporates
a separate LCD Display, which can show CH1/CH2 VOLT/DIV,
TIME/DIV, X‐Y MODE, and Frequency.
10
72-6802 User Manual