Yamaha YZ250F(R) Owner's Service Manual page 464

FRONT WHEEL AND REAR WHEEL
5 - 6
5. Install:
Wheel axle 1
G
NOTE:
Apply the lithium soap base grease on the
wheel axle.
6. Install:
Nut (wheel axle) 1
G
105 Nm (10.5 m · kg, 75 ft · lb)
7. Tighten:
Bolt (axle holder) 1
G
23 Nm (2.3 m · kg, 17 ft · lb)
NOTE:
Before tightening the bolt, fit the wheel axle to
the axle holder by stroking the front fork sev-
eral times with the front brake applied.
8. Install:
Brake hose 1
G
10 Nm (1.0 m · kg, 7.2 ft · lb)
To brake hose holder 2.
NOTE:
Before tightening the bolt (brake hose holder),
align the top a of the brake hose neck with the
brake hose holder bottom b. Then pass the
brake hose in front of the axle boss c and fit it
into the hose groove d so that the brake hose
does not contact the nut (wheel axle).
CHAS