Figure 22 - Typical Installation Using A Cable Modem - Honeywell 900U02-0100 User And Installation Manual

 Using the Designer Software to configure:
 Alarm Groups and Event Groups
 Assignment of specific alarms to priority and e-mail enabling
 E-Mail address lists
 SMTP mail server IP address
 Default gateway must be configured in order to send e-mail. With redundant controllers, two
default gateways need to be configured; one for each of the redundant networks (assuming both
are being used). This will typically be the LAN side IP address of the routers used to connect
the controller to the external network.
 Installing and configuring hardware
Note: This data is included for reference. The following items should be implemented by qualified
IT/MIS personnel.
 Install and configure a Router to provide isolation and security. (Figure 22) (This should be
part of standard network installation.)
 Install and configure internet access to Simple Mail Transport Protocol (SMTP) server. This
may include the location of an existing server on an existing network.
Note: Consult your service provider for availability of access to network, local cable, or DSL in your
area.
Figure 22 – Typical installation using a Cable Modem
Revision 10 ControlEdge HC900 Process & Safety Controller User and Installation Manual
May 2019
37