Adjusting The Footboard Assembly; Angle - Invacare Pronto M91 Service Manual

SECTION 7—FOOTBOARD ASSEMBLY
Wheelchair Frame
DETAIL "A" - Bottom View of
Mounting
Footboard
Hole
Quick Release Pin
Quick
Release
Detent Ball
Pin
Detent Balls
Footboard Assembly
Outer Edge of Tube
FIGURE 7.1 Removing/Installing the Footboard Assembly

Adjusting the Footboard Assembly

Angle

NOTE: For this procedure, refer to FIGURE 7.2.
1. Loosen the jam nut and set screw located underneath the rear of the footplate.
2. Adjust the set screw in or out to obtain the desired footboard assembly angle.
3. Thread the jam nut and washer inward until flush with the footboard bracket.
4. Securely tighten the jam nut and washer to secure the mounting screw in place.
Set Screw, Washer and Jam Nut
Footboard Assembly
FIGURE 7.2 Adjusting the Footboard Assembly - Angle
79 ®
Part No. 1125038 Pronto M91™and M94™