SECTION 5—ARMS
Replacing Van Seat Armrest Pad Assembly
NOTE: For this procedure, refer to FIGURE 5.3.
1. If necessary, remove the joystick. Refer to Disconnecting/Connecting the Joystick on
page 112.
2. Remove the mounting screw, washers and locknut that secure the existing armrest pad
assembly to the arm post.
3. Position the new armrest pad assembly on the armrest post and secure with the
mounting screw, washers, and locknut. Refer to FIGURE 5.3 for correct hardware
orientation.
4. If necessary, install the joystick. Refer to Disconnecting/Connecting the Joystick on
page 112.
5. Repeat STEPS 2‐4 for the opposite armrest plate, if necessary.
Mounting Screw
Washers
FIGURE 5.3 Replacing Van Seat Armrest Pad Assembly
®
Pronto
M91™and M94™
Washer
68
Armrest Pad
Assembly
Arm Post
Locknut
Part No. 1125038