SECTION 7—FOOTBOARD ASSEMBLY
Wheelchair Frame
DETAIL "A" - Bottom View of
Mounting
Footboard
Hole
Quick Release Pin
Quick
Release
Detent Ball
Pin
Detent Balls
Footboard Assembly
Outer Edge of Tube
FIGURE 7.1 Removing/Installing the Footboard Assembly
Adjusting the Footboard Assembly
Angle
NOTE: For this procedure, refer to FIGURE 7.2.
1. Loosen the jam nut and set screw located underneath the rear of the footplate.
2. Adjust the set screw in or out to obtain the desired footboard assembly angle.
3. Thread the jam nut and washer inward until flush with the footboard bracket.
4. Securely tighten the jam nut and washer to secure the mounting screw in place.
Set Screw, Washer and Jam Nut
Footboard Assembly
FIGURE 7.2 Adjusting the Footboard Assembly - Angle
®
™
62
Pronto
M91 and M94
Part No. 1125038