11 SETUP/MAINTENANCE
11.11 Adjusting the Footboard Assembly
Angle
For this procedure, refer to FIGURE 6.
1.
Loosen the jam nut and set screw located underneath on the back
of the footplate.
2.
Adjust the set screw in or out to obtain the desired footboard
assembly angle.
3.
Thread the jam nut and washer inward until it is flush with the
footboard bracket.
4.
Securely tighten the jam nut and washer to secure the mounting
screw in place.
Invacare® Pronto® M91™
Set Screw, Washer and Jam Nut
FIGURE 6
Adjusting the Footboard Assembly - Angle
104
Footboard
Assembly
Part No 1143153