Arm Service Procedures for ASBA and Adjustable
ASBA Seat
Make sure the flip back armrest release levers and height adjustment levers are in
the locked position before using the wheelchair.
Removing/Installing Flip Back Armrest
NOTE: For this procedure, refer to FIGURE 5.4.
NOTE: Flip back armrest release lever must be in unlocked position when placing armrest into the
arm sockets.
NOTE: Reverse this procedure to install the flip back armrest.
1. If necessary, disconnect the joystick. Refer to Disconnecting/Connecting the Joystick
on page 112.
2. Unlock flip back armrest by pulling flip back armrest release lever into the unlocked
(horizontal) position.
3. Remove quick release pin securing the flip back armrest to the wheelchair frame.
4. Pull UP on the flip back armrest and remove the armrest from the arm sockets.
5. Repeat STEPS 2‐4 for the opposite flip back armrest, if necessary.
Flip Back Armrest
NOTE: ASBA armrest
shown. ADJUSTABLE
ASBA armrest works the
same way.
Rear Arm Socket
FIGURE 5.4 Removing/Installing Flip Back Armrest
Part No. 1125038
WARNING
Quick Release Pin
Flip Back Armrest
Release Lever
Front Arm Socket
69
SECTION 5—ARMS
Locked
(Vertical)
Unlocked
(Horizontal)
Seat Frame
®
Pronto
M91™and M94™