Section 6-Front Riggings; Installing/Removing Front Riggings; Installing; Removing - Invacare Pronto M91 Service Manual

SECTION 6—FRONT RIGGINGS
After ANY adjustments, repair or service and BEFORE use, make sure that all
attaching hardware is tightened securely - otherwise injury or damage may result.
DO NOT stand on the front riggings, otherwise damage may occur. When getting
in or out of the wheelchair, make sure that the footplates on the front riggings are
in the upward position or moved out of the way.
Before performing any maintenance, adjustment or service verify that On/Off
switch on the joystick is in the OFF position.
While the wheelchair is moving, minimum ground clearance for the front rigging is
three inches. If the wheelchair is not moving, the front rigging MUST maintain a mini-
mum of one inch ground clearance - otherwise personal injury and damage may result.

Installing/Removing Front Riggings

NOTE: For this procedure, refer to FIGURE 6.1.

Installing

1. If necessary, remove the footboard.
Refer to Removing/Installing the
Footboard Assembly on page 78.
2. Turn front rigging to the side (open
footplate is perpendicular to wheelchair)
and position mounting holes in the front
rigging hinge plates with hinge pins on
the wheelchair frame.
3. Install the front rigging hinge plates onto
the hinge pins on the wheelchair frame.
4. Push the front rigging towards the
inside of the wheelchair until it locks
into place.
NOTE: The footplate will be on the inside of the wheelchair when locked in place.
5. Repeat STEPS 2‐4 for opposite side of wheelchair.

Removing

1. Push the front rigging release lever inward and rotate the footrest out.
2. Lift up on front rigging and remove from the wheelchair.
3. Repeat STEPS 1‐2 for opposite side of wheelchair.
Part No. 1125038
SECTION 6—FRONT RIGGINGS
WARNING
WARNING
Hinge
Pins
Front Rigging
Release Lever
Front Rigging
Hinge Plate
FIGURE 6.1 Installing/Removing Front
71
Telescoping
Front Rigging
Support
Riggings
®
Pronto M91™and M94™