SECTION 6—FRONT RIGGINGS
Spacer
Locknut
FIGURE 6.7 Adjusting/Replacing Telescoping Front Rigging Supports
Adjustable ASBA
If the telescoping tubes need to be extended greater than two inches, then the seat
MUST be repositioned rearward to ensure stability - otherwise personal injury and/
or damage to the wheelchair and surrounding property may result.
NOTE: For this procedure, refer to FIGURE 6.8 on page 77.
1. Remove the two cap screws, spacers and threaded blocks securing the telescoping
front tube to the side rail.
2. Perform one of the following:
• Slide existing telescoping front rigging support to one of six depth positions.
• Remove existing telescoping front rigging.
3. Secure the telescoping front tube to the side rail at the desired depth with the existing
two cap screws, spacers and threaded blocks.
4. Repeat STEPS 1 to 3 on the opposite side if desired.
®
Pronto
M91™and M94™
Mounting
Screws
Spacer
Locknut
WARNING
76
Telescoping Front
Rigging Support
Part No. 1125038