SECTION 8—FOOTBOARD ASSEMBLY
DETAIL "A" - TOP VIEW
Shroud
OF FOOTBOARD
Footboard
Outer Edge of Tube
Assembly
Detent Balls
Mounting
Hole
Quick
Quick Release Pin
Detent
Release Pin
Ball
FIGURE 8.1 Removing/Installing the Footboard Assembly
Adjusting the Footboard Assembly
Angle
NOTE: For this procedure, refer to FIGURE 8.2.
1. Loosen the jam nut and set screw located underneath on the backside of the footplate.
2. Adjust the set screw in or out to obtain the desired footboard assembly angle.
3. Thread the jam nut and washer inward until it is flush with the footboard bracket.
4. Securely tighten the jam nut and washer to secure the mounting screw in place.
Set Screw, Washer
and Jam Nut
Footboard Assembly
FIGURE 8.2 Adjusting the Footboard Assembly - Angle
41
Part No. 1143206
Pronto® M41 with SureStep®