SECTION 4—SEAT
Back Cane
Cane Bracket
Upper Hex Screw
Washers
Lower Hex Screw
Removing/Installing the Spreader Bar
NOTE: For this procedure, refer to FIGURE 4.17.
Removing
1. Remove the two mounting screws and locknuts securing the spreader bar to the back
canes.
2. Remove the spreader bar from the back canes.
Installing
1. Position the spreader bar against the back canes.
2. Loosely install the two mounting screws and locknuts hold the spreader bar against
the back canes.
3. Adjust the position of the spreader bar until it is parallel with the ground/floor.
4. Torque the mounting screws to 13 ft‐lbs ± 20%.
Locknut
Back Cane
FIGURE 4.17 Removing/Installing the Spreader Bar
®
Pronto
M91™and M94™
Locknuts
Slot
FIGURE 4.16 Removing/Installing the Back Canes
Spreader
Bar
Locknut
Mounting
Screw
58
Mounting
Screw
Part No. 1125038