Section 4-Footboard Assembly; Removing/Installing The Footboard Assembly; Removing; Installing - Invacare At’m Service Manual

SECTION 4—FOOTBOARD
ASSEMBLY
After any adjustments, repair or service and before use, make sure that all attaching
hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service verify that On/Off
switch on the joystick is in the off position.
DO NOT stand on the flip-up footboard. When getting in or out of the wheelchair,
make sure that the flip-up footboard is in the upward position.
Limited clearance between footboard and caster - The user's feet MUST remain on
the footboard while operating the chair. If the user's feet are allowed to rest off the
side of the footboard they may come in contact with the caster possibly resulting in
injury.

Removing/Installing the Footboard Assembly

NOTE: For this procedure, refer to FIGURE 4.1.

Removing

1. Remove the two (2) mounting bolts that
mount the footboard assembly to the
base frame.
2. Remove the footboard assembly from
the base frame.

Installing

1. Align the footboard assembly with the
adjustment holes in the base frame.
2. Install the footboard assembly using
the two (2) mounting bolts and
locknuts.

Adjusting Footboard Assembly Height

NOTE: For this procedure, refer to FIGURE 4.1.
1. Remove the footboard assembly. Refer to Removing/Installing the Footboard
Assembly on page 25.
2. Align the footboard assembly to one (1) of three (3) desired adjustment holes on the
base frame.
3. Attach the footboard assembly to the base frame with two (2) mounting bolts and
locknuts. Securely tighten.
Part No. 1125078
SECTION 4—FOOTBOARD ASSEMBLY
WARNING
Mounting
Bolt
Footboard
Assembly
FIGURE 4.1 Removing/Installing the
Footboard Assembly
25
Base Frame
Adjustment
Holes
Mounting
Locknuts
Bolt
At'm