• Rear Shroud ‐ M91 Before 7/14/03 ‐ Perform the following:
NOTE: The rear shroud on the M91 built before 7/14/03 can be opened and closed with out
being removed from the wheelchair. The rear shroud should be removed only if being replaced.
To open the rear shroud refer to STEP ii below.
i. Open rear shroud by turning the knob 90° until detent catch is felt, then slide
rear shroud toward the rear casters and lift top edge away from the rear of the
wheelchair frame (Detail "C" of FIGURE 9.1).
ii. Grasp the bottom edges of the rear shroud sides.
iii. Gently pull the rear shroud sides away from the channels in the rear frame until
the rear shroud mounting pins are clear of the wheelchair frame and remove
the rear shroud from the wheelchair frame.
• Rear Shroud ‐ M91 After 12/18/03 and M94 Wheelchairs ‐ Perform the following:
i. Remove the two mounting screws and locknuts securing the charger port to the
rear shroud.
ii. Remove the mounting bolt and washer securing the rear shroud to the base
frame and remove rear shroud from base frame (Detail "C" of FIGURE 9.1).
Part No. 1125038
SECTION 9—SHROUDS/FRAME
89
®
Pronto
M91™and M94™