Replacing An Iopx.ethernet Cable - HP NetServer AA 4000 Administrator's Manual

Chapter 9

Replacing an IOPx.Ethernet Cable

The IOPx.Ethernet cable connects the IOP to the public Ethernet.
Caution: Before proceeding, make sure you are properly grounded using, for instance, a
wrist strap with an attached alligator clip that is connected to an appropriate
ground.
To replace an IOPx.Ethernet cable:
Step Action
1 Obtain a replacement Ethernet cable from
your service provider that meets the
specifications for your network.
2 Using Endurance Manager, make sure that
the other IOP is active and that it has public
network connectivity.
3 Remove the IOPx.Ethernet cable by
detaching it from the IOP and the public
Ethernet network.
4 Install the new Ethernet cable by attaching
it to the IOP and the public Ethernet.
5 Make sure that the Ethernet connection that
uses the replacement cable is active and on
standby (appears dark green).
218
Notes
The IOPy.Ethernet is online or on standby.
Use Endurance Manager for this step.
Maintenance