Rebooting The Server; Shutting Down The Server - HP NetServer AA 4000 Administrator's Manual

Chapter 9

Rebooting the Server

Before you reboot the server, consider the fact that completing this procedure removes your
server from service. Make sure that you schedule an appropriate time and that you have
completed any necessary backups before starting this procedure.
To reboot the server, issue an Endurance Manager Server Shutdown command.

Shutting Down the Server

Before you shut down the server, consider the fact that completing this procedure removes your
server from service. Make sure that you schedule an appropriate time and that you have
completed any necessary backups before starting this procedure.
Note: You must complete the following procedure onsite. You cannot shut down the
CE operating system using remote Endurance Manager.
To shut down the server:
Step Action
1 From Endurance Manager on an IOP, issue
a Server Shutdown command
2 After that IOP shuts down its Windows NT
operating system, power it off.
3 Power off the remaining IOP and both CEs
after they completely shut down.
214
Notes
This prevents the server from rebooting
automatically.
Do this only after the components are completely
shut down.
If the other IOP is located too far away (i.e.,
SplitSite), it restarts.
• In this case, go to that site, and power off the CE
in the other tuple.
• Then perform a Windows NT shutdown on that
IOP.
• After the shutdown is complete, power it off
also.
Maintenance